View Single Post
Old 11-03-2009, 08:09 PM
Kevron99's Avatar
Kevron99 Kevron99 is offline
Motorized Bicycle Elite Member
Join Date: Aug 2009
Location: Howell, New Jersey
Posts: 261
Default Re: CARBS...I give up

Ok I just got back from a test run after I uninstall and checked the carbs again and to make sure that the throttle screw is lifting the slide.
After the test drive, and when I stop, slightly disengage the clutch or press the clutch lever at 50% the bike idles but revving very high in full RPM, I tried to loosen the idler screw while the clutch is at 50% and the revving brings down a little bit, now it idles but RPM is still high. When I disengage the clutch at 100% the motor stops....its a real bummer. Any help from the forum is much needed...Thanks

My next is to try Venice suggestions...Replace the plug and plug wre
Reply With Quote