View Single Post
Old 10-18-2009, 11:26 PM
flybytaco's Avatar
flybytaco flybytaco is offline
Metal Molding Madman
Join Date: Oct 2009
Location: seekonk MASS
Posts: 1,176
Default Re: Is there a difference between the skyhawk and the starfire

Originally Posted by Hot Dog Piggy Tails View Post
No actually there is a big difference first is the match as far as the transfer ports then there is the Quality of the lower end Bearing (23 Needle verses 16 needle in a poorly Engineered cast)
The Nantong Jiali Manufacturer is known as the better if not the best engine manufacturer exporting these and have lost contracts with people Because they refuse to Mass produce cheap engines.

If you've replaced A starfire with a Jet your Stafire was probably a 48cc'er thats about the only ones left. Also the Starfire is the factory that your Jet was Manued at..And if it is is out of one of the First two shipments of Jet Engine they have lower end problems due to the fact a Customer I wont say no names but is actually thier competitor convinced them to use a Poorly casted Lower end Needle casing. They all need replaced. As a matter of fact the ones that are correct and Have 23 needles are still on thier way too them. I never received the 16K Needle bearing with the problem because I have the prints too it and refused to Allow them every order to put them on the bottom of my Connecting rod.

I deal with this factory and its Management Exporter and are very good friends talking at least once a week.
It says it was manufactured on 7 2009. is that one of the bad ones? and yes it was a48 verry slow I baught the limited edition black one It def is a runner
Reply With Quote