Thread: clutch lever!!!
View Single Post
Old 05-25-2008, 04:24 PM
Saddletramp1200's Avatar
Saddletramp1200 Saddletramp1200 is offline
Custom MB Buiilder
Join Date: May 2008
Location: Houston, Texas
Posts: 1,418
Thumbs up Re: clutch lever!!!

Hey there, Go you have room to ajust the cable at the motor? If so ajust it there. If not take the cable out of the clutch lever Then ajust it to disengage
the clutch, leaving just enough room to put it back in the handle. That might help. Last resort, take cotter pins a little bigger than the inside cable & put them between the lever housing & the lever its self. Spread them with a flat screwdriver and close them with pliers after they have been placed on the cable. cut off excess. Tape em' up so U don't cut yourself.
Reply With Quote