Thread: Clutch problem
View Single Post
Old 09-29-2009, 11:57 AM
wes's Avatar
wes wes is offline
Motorized Bicycle Elite Member
Join Date: Aug 2009
Location: Tucson Az
Posts: 207
Default Re: Clutch problem

Ive had this problem, it was on a motor with 6-7000 miles on it and around 4500 or so the ball bearing was warn in side where the rod passes through the engine, this is behind the casing on the lever side, ive also had this problem when the clutch pads were warn out and i adjusted the flower nut to tight after replacing, if this is a new motor and the clutch worked fine before than i would listen to Noco, its probly an easy fix with the cable adjustment, good luck!!!
Reply With Quote