View Single Post
Old 09-22-2009, 08:12 PM
tsmra tsmra is offline
Motorized Bicycle Newbie
Join Date: Aug 2009
Location: Berks Co. Pa.
Posts: 10
Default Re: Has any one else run across this one?

It was part of the 66CC kit I ordered. I'll refrain from stating where the kit came from. Don't want to start a bash fest, just curious how often this might come up. If I reuse the rag joint that 3rd joint will get trimmed. Honestly I just don't see how the backing pieces would have laid flat with that much over lap on each segment (1st picture in original post). Had I just trimmed that 3rd segment it would have probably turned out fine. Those little bolts got cranked down ALOT to smooth out the high spot with in ~1mm. Half stepping it again thatís all. It will be a little while before the engine gets fired, after looking in the exhaust port there is a little flash that should probably be removed. Working on 2 stroke motors is all new to me. Time to start reading up. Winter is right around the corner and I HATE the cold and snow so there is plenty of time.
Reply With Quote