View Single Post
Old 09-21-2009, 07:04 PM
tsmra tsmra is offline
Motorized Bicycle Newbie
Join Date: Aug 2009
Location: Berks Co. Pa.
Posts: 10
Default Has any one else run across this one?

The backing plates for the rag joint all over lapped by 1/8 to 1/4 inch each. I cut 2 of the joints and the 3rd joint fell into place. That is until it was assembly time. that 3rd joint overlapped again so I just followed the advice given by the seller and preyed the apart till it lay flat and went about tighten down the nuts. Well there was quite a high spot on the sprocket and as it turned out it was right over that 3rd joint.
As it turns out the whole thing has to come apart any way because there is a clearance issue with chain and tire ( flat sprocket ) so I was thinking of putting an extra piece of rubber between the out side rag joint and the sprocket. Also think I will order a Manic Mechanic sprocket adaptor latter this week.
Couple of pics to help explain.
Attached Images
File Type: jpg DSCF0248rs.jpg (151.3 KB, 51 views)
File Type: jpg DSCF0250rs.jpg (165.4 KB, 47 views)
File Type: jpg DSCF0253frs.jpg (119.9 KB, 61 views)

Last edited by tsmra; 09-21-2009 at 09:29 PM. Reason: Reformat pictures
Reply With Quote