View Single Post
Old 09-01-2009, 03:47 PM
azbill's Avatar
azbill azbill is offline
Motorized Bicycle Elite Member
Join Date: May 2008
Location: Fountain Hills, Arizona
Posts: 3,357
Default Re: About Carburetor

I have found that some factories never notice the seam in the floats when assembling
if the seam is on the bottom, it WILL leak...much less rate of leaking when the seam is at the top
after 2 bad ones, I started checking all of them
the seam is approx 2/3 of the way along the outside ring of the float ( I think it was dax who clued me into even looking )

Intelligence is learning from your own mistakes,
Wisdom is learning from the mistakes of others

EZ Motorbike Dealer - Fountain Hills, AZ
EZ Motorbike of Fountain Hills
Reply With Quote