View Single Post
Old 08-18-2009, 10:13 PM
HoughMade's Avatar
HoughMade HoughMade is offline
Motorized Bicycle Elite Member
Join Date: Apr 2008
Location: Valparaiso, IN
Posts: 624
Default Re: Springer Front End

Here's what I did with the springer- blue loctite on the pivot bolt and the small bolts holding the top of the arms to the saddle.

For the big center bolt, I screwed the bolt in far enough to put a jam nut on the other side of the plate- it's not tpp tight, but it kicks the front end out nicely. I used blue loctite on that too and tightened the jam nut on there tight. I have never had to tighten any of them since- almost 2 years on that setup.
29/10ths cubic inches of raw power.
HoughMade at

Last edited by HoughMade; 08-19-2009 at 09:29 AM.
Reply With Quote