Wiring help please

SeattleMike · #1 (**permalink**) 03-23-2008, 12:13 PM

Hey guys, I'm connecting all the wires together on my 80cc kit, and the instruction manuel describes how to connect wires that are all different colors than the wires I have.

The two wires coming from the kill switch: 1 black, 1 yellow
The two wires coming out of the ignition coil are: 1 black, 1 blue
The three wires coming out of the engine are: 1 turquoise, 1 black, 1 white.

Can any of you guys tell me which wires to connect to which wires? Like I said, my manuel is telling me to connect the purple wire to the green, and stuff like that- no help whatsoever!

**CRUISER** · #2 (**permalink**) 03-23-2008, 12:23 PM

my directions i got with my motorized bicycle for wiring sucked to. see if this helps How to wire Chinese 2-Stroke bicycle engine
yours is probably black to black to black and then the yellow and turquoise together. the white one cap off unless you are running a light or electrical for it. that is a 6 volt power wire

**RedB66** · #3 (**permalink**) 03-23-2008, 04:49 PM

The white is for aux power. On my stretch I have the two wires coming from the kill switch to the two wires (black and blue) and everything works fine. I use the white wire to power my rear light. I would suggest connecting the blacks together (all 3) yellow, blue and turquoise together. Use the white on only if you are running a light......Two connections...three wires each.