clutch lever

my clutch lever at the engine moves out and it should move in after its connected to the cable I cannt connect the cable cause it would do no good pull cable an it would not go any where cause it swing away from engine not to it where the cable goes through ????????help

It will move inward just tight at first.......

__________________
"No such thing as a stupid question, just a stupid answer"

48cc Grubee Starfire Round Head......

I hope when I try it wont go a bit but it will move away from engine and stop about where it should if it went the other I`ll look at it again thank you

o k I looked at it if I try and turn it the way it should go it starts to go into the round part of the lever the piece is pressed in wrong when the piece is half way out 90 degree faceing away from engine it get a gap that the end part from the engine is apply pressure and it stops it should be the other way tward the engine so it exactaly opp

o.k I put a **** of a lot into it and it moved seem like that would break something being that hard to move

Yea my bad I should have let him know that the arm and rod where petrified titanium, and give him time, like some he may end up throwing it from a speeding truck AND running it over LOL.....

Glad you figured it out!!!!!!!!!!!

__________________
"No such thing as a stupid question, just a stupid answer"

48cc Grubee Starfire Round Head......