Reed Valve experiences

scott83 · #1 (**permalink**) 11-02-2009, 01:16 PM

I just purchased a few pocket bike reed valve assemblies and some aluminum bar stock... I was wondering if anyone has had problems with crank seals blowing out when adding reeds to these motors...any feedback would be greatly appreciated

skipu · #2 (**permalink**) 11-05-2009, 10:44 PM

Quote:

Originally Posted by scott83

I just purchased a few pocket bike reed valve assemblies and some aluminum bar stock... I was wondering if anyone has had problems with crank seals blowing out when adding reeds to these motors...any feedback would be greatly appreciated

i run em no problems i dont think there is enough case pressure but when getting a little old may start sucking air / with it debris try it and see what happens

scott83 · #3 (**permalink**) 11-06-2009, 08:27 AM

Good to hear.. I'm still waiting on barstock to make the adapter plate. Thanks for the Info.