View Single Post
  #8 (permalink)  
Old 11-13-2009, 03:05 PM
Goat Herder's Avatar
Goat Herder Goat Herder is offline
Motorized Bicycle Elite Member
 
Join Date: Apr 2008
Location: Albuquerque
Posts: 1,202
Default Re: Morini Update! How's yours doin?

Cool info guys. So far so good at this point. I do notice a strange vibe like the rear tire is rubbing sometimes at coasting Idle. Its not a rear tire rubbing. When I bench tested my motor during my build [ I needed the inspiration at the time] at Idle I got an occasional sick duck sound. I dismissed it at the time because it was a new motor figured it needs a load and gracefully broken in. I now suspect maybe there is more too that scenario but don't know . As any info or real here say on these Morinis is just lacking where ever I have looked. New ground for me. The service manual PDFs I found here on the sight does not even tell the spark plug gap? All though there was some cool torque specs and diagrams. I was a little disappointed.

Hearing that the spark plug wire is special I will rub proof it with fuel line cut length ways with a razer sleave it on tie it off to the bike where it cannot rattle. Was going to do that anyway. I am getting better gas miles than 90 mpg with the J shaft, but not if I get on it. I only got 150 miles on the pig so far.
__________________
One can do anything they set there mind to.... Do a good thing...
http://www.sdc.org/fattire/goatheads.html I get no flats..

Last edited by Goat Herder : 11-13-2009 at 03:50 PM.
Reply With Quote